facebook icon youtube Linkedin

| Select:

  • Ελληνικά
  • English
  • Shqip
  • Pусский
header-banner
Info: Your browser does not accept cookies. To put products into your cart and purchase them you need to enable cookies.

DUROSTICK VISTA

Solvent-based ΜΑΤ varnish for pressed cement mortar and natural stone

DUROSTICK VISTA

DUROSTICK VISTA

TECHNICAL SPECIFICATIONS

Form - Colour

Liquid - transparent

Specific gravity

0.94±0.05 gr/ml

Application temperature

From +5 °C to +35 °C

Temperature resistance

From -30 °C to +80 °C

Gloss

1st coat: mat finish
2-3rd coat: satin finish

Drying time

3 - 4 hours

VOCs (Volatile Organic Compounds): Limit value of maximum VOC content according to EU (Directive 2004/42/ΕC) for the particular product (class Α/g: «Binding primers», Type D):750gr/lt (2010). Ready to use product contains maximum 630 gr/lt.

Product Certificates:

PROPERTIES

Acrylic clear impregnation varnish with mat finish, with strong UV filters, extremely resistant to solar radiation. Provides long service life. Suitable for use on exterior and interior surfaces, does not peel off or turn yellowish over time.
Creates a strong, water repellent and oil repellent protective film, without glazing. Brings the best out of any surface by highlighting their natural tones.
The special appearance rendered by applying Durostick VISTA makes it the ideal choice for spreading the surface of DUROSTICK DS-250 pressed cement mortar as well as any natural stone floor or building facade.
On cladding consisting of natural stone, on building floors and facades, spreading with two layers of Durostick VISTA varnish will lead to surfaces free from glazing, wet look and highlighting the graining of the stone originally used on the clad surface.

APPLICATIONS

Durostick Vista varnish is applied where requirements call for a mat surface.
Furthermore, where particular resistance to abrasion and protection against adverse weather conditions are necessary (sunlight and snow) as well as frequent cleaning of interior areas.

CLEANING
Clean tools after use with DUROSTICK THINNER 101 or white spirit.


INSTRUCTIONS FOR USE

1. Surface preparation:


Surfaces must be clean and thoroughly dry. They must have acquired their full mechanical strength. (about 28 days for pressed cement mortar). For natural stone, allow 3-4 weeks after joint filling and make sure they are well cleaned with D-7 natural stone cleaner by DUROSTICK to remove mortar residues from joint filling.


2. Application:

The DUROSTICK VISTA is a ready to use product. Application on clean, dry surfaces is carried out using varnish roller or flat brush in two coats, allowing 3-4 hours between consecutive applications.

CONSUMPTION


1 lt/5-8 m², depending on surface absorption

STORAGE


Stored in closed containers, away from sources of heat, for a minimum of 24 months after production date.

SAFETY DIRECTIONS


The product is classified as extremely flammable and harmful in case of contact with the skin or if inhaled. It is recommended that the product is kept away from children and applied in well ventilated areas. Before using, refer to the cautions on the product's package or in the material safety data sheet.

REMARKS

• In case climbing moisture is suspected on both applications, it is recommended to first apply a single coat of RENOLIT siloxane waterproofing agent by DUROSTICK, thus preventing moisture from coming into contact with the varnish.
• Surfaces treated with DUROSTICK VISTA varnish must not come into contact with water for minimum 24 hours after application.
• After drying, the product is harmless.

PACKAGING


Carton box with 12 pcs., 750ml each
Carton box with 6 pcs., 2.5 lt each