facebook icon youtube Linkedin

| Select:

  • Ελληνικά
  • English
  • Shqip
  • Pусский
header-banner
Info: Your browser does not accept cookies. To put products into your cart and purchase them you need to enable cookies.

DUROSTICK D-32

Fast setting repair plaster, white

DUROSTICK D-32

DUROSTICK D-32

TECHNICAL SPECIFICATIONS

(Measurement conditions: 20 oC and 65% RH)

Form - Colour

Cementitious powder - White

Toxic/flammable (per ΕΝ 88/379)

No

Dry mortar apparent specific gravity

1.60±0.05 kg/lt

Damp mortar apparent specific gravity

1.75±0.05 kg/lt

Maximum grain diameter

1.0 mm

Water requirements

5.5 lt water in 25 kg mortar

Application temperature

From +5 °C to +35 °C

Temperature resistance

From -30 °C to +80 °C

Pot life

1 hour at +20 °C

MECHANICAL STRENGTH

Resistance for 28 days per ΕΝ 1015-11 to:

• Flexion

1.50±0.40 Ν/mm²

• Compression

4.60±0.30 Ν/mm²

Experimental measurements were performed according to ΕΝ 998-1 at the DUROSTICK chemistry laboratory and were verified by audit performed by EKEPY (# 135/2009).

Product Certificates:

PROPERTIES


Plaster with increased early strength, easy to use, crystalline based, providing strong adhesion and resistance to all masonry repairs. Its granulometry is identical to top coat plasters. The result is that it blends perfectly and offers an ideal solution for small repair jobs. It is classified under class GP-CS II per ΕΝ 998-1.

APPLICATION


D-32 plaster is suitable for restoration of severe cracks 2-10 mm thick on plaster and to repair damaged corner edges. Replaces top coat plaster in expedient jobs. Covers holes around wall switches and switch boards that occur after electrician jobs are over. Repairs defects that surface after the completion of works by aluminum fitters, plumbers and tile fitters. Its efficiency in everyday painter jobs makes it an indispensable tool. Adding acrylic emulsion D-20 in water to a mixing ratio of 1 part emulsion to 3 parts water increases adhesion, strength and watertightness while improves plasticity as well.

INSTRUCTIONS FOR USE

1. Surface preparation
To ensure satisfactory product adhesion, surfaces shall be firm and free from loose areas. It is necessary to wet them before plaster application.

2. Application
Mix the content in water in a ratio of 25 kg D-32 to 5.5 - 5.75 lt water (1.1 lt : 5 kg), using concrete mixer or power drill in low revs until the mix is fully homogenized.
Spread the plaster with trowel or floar and sand it with grinder after 30-40 minutes.

CONSUMPTION


15 kg/m²/cm thickness of plaster

STORAGE


Stored in tightly closed packages, in dry and shaded areas for a minimum of 12 months after production date.

SAFETY DIRECTIONS


The product contains Portland cement and is classified as irritant. Before using, refer to the cautions on the product's package or in the material safety data sheet.

PACKAGING


Carton box with 4 bags, 5 kg each
Paper bag, 25 kg on 1,500 kg pallet